New Zealand's first and last gasworks

the best example of working gasworks machinery in the world

What the Gasworks did?

There were four main functions carried out at the gasworks:

  • Gas manufacture
  • Gas treatment
  • Gas pumping
  • Gas storage

The Dunedin Gasworks Museum complex consists of the main pumping section of the works, together with some of the gas treatment plant.

Various exhausters were used to draw gas from retorts. The gas was passed through to two condensers beside the boiler house, which cooled it down. This condensed out mauch of the coal tar in the gas, which was fed into storage tanks. The gas was then passed through the electrostatic detarrer and the ammonia washer to remove urther impurities. Finally the gas passed through the purifiers, which removed any hydrogen sulphide that might be present. Although the main purifiers have not survived, the fitting shop was originally built to house a set of similar units for the 1900 watre gas plant.

 

Once the gas had been fully treated, it was pumped through the Station Meter to measure the volume produced, and then stored in the gasholders. The last surviving gasholder was situated at Kensington, and was demolished in 2000. To supply the city with gas, several boosters in the works yard (now gone) fed the low pressure system during the day, gener¬ally being shut down at 11 pm, when supply was maintained by the pressure inside the gasholders. During periods of high demand the Bryan Donkin Booster was used to supply high pressure gas to outer areas, when outlying governors then reduced the pressure for domestic use.

Museum Entry Fee

ADULTS and TEENS
$5.00

Twitter Feeds

Subscribe to our mailing list

Please complete the following details:

 

Your email is safe with us. We do not distribute or share our lists.

The Gasworks NZ : digital literacy hub teaching tech, science, art and everything in between



Blog Posts

More problems, but hope is at hand

Following a very frustrating time the previous  Sunday, when the boiler would not start, Tom spent 6 hours working on the problem on Saturday 22nd,...Read More

A sight not often seen

Tom has opened up the crankcase of the Reader steam engine, in the quest for a knocking noise. Seems the oil pump had not been working properly, but...Read More